Author Archives: pclifton

Title mostly sums up tonight, the tweaks all around to accommodate the new three-lever throttle quadrant are now done. I ended up managing to do it without having to do any major rework on the bulkhead passthrough holes at all, … Continue reading →

Some more playing with the throttle linkage tonight. Last time I was thinking that replacing the rod end bearing on the forward end of the linkage with a clevis might solve my alignment issues without needing any bulkhead passthrough hole … Continue reading →

Well, my intent for tonight was to put in some more time on the throttle quadrant situation, but that didn’t really happen. After the last work session, I went back and read through the whole odyssey from the first time … Continue reading →

Well, tonight is a shining example of what I’m going to call “cascading dependencies.” My initial plan tonight was to start by just finishing the few remaining steps in the current construction manual section, then go back to the incomplete … Continue reading →

So I spent most of the day working outside, yard work and so forth. But after it got dark and I had some dinner, it was time to get out and do some plane work. I started off working on … Continue reading →

So tonight was mostly spent getting those nutplates riveted to the seat ramp components. Took a bit of creativity to get some of the rivets done in some tight corners. These parts should be pretty well done now, though I’ll … Continue reading →

Not a ton of stuff tonight. I started working on prepping the front seat ramp parts. Nothing unusual here – final-drilling some nutplate rivet holes, trimming some extra material, and deburring all the holes and edges. Deburring here was more … Continue reading →